![]() ![]() If thereâs anything else I can provide to help please let me know. Pins.h:790:8: error: #error âNo E stepper plug left for Y2!â In file included from sketch\MarlinConfig.h:40:0, My issue is on comiling I get the following error Īrduino: 1.8.9 (Windows Store 1.8.21.0) (Windows 10), Board: âArduino/Genuino Mega or Mega 2560, ATmega2560 (Mega 2560)â ![]() I do not have any endstops, I donât really think I need them - Iâve got the printed pieces to get it all square and thatâs good with me. #define INVERT_Y2_VS_Y_DIR true // Set âtrueâ if Y motors should rotate in opposite directionsĪnd I believe I did all of that correct, I do want it to be true as itâs a belt not leadscrew. #define INVERT_X2_VS_X_DIR true // Set âtrueâ if X motors should rotate in opposite directions So I went back and trued to make the dual steppers true ![]() So Iâve gotten it back to Marlin, and tested it without having the dual motors set-up - everything working just fine. Getting closer over here, hoping you can help me down the home stretch only issue Iâm having now is - I want to run my second X Stepper off of E0, and second Y off of E1. Prior to starting my switch over, the CNC was working just fine and making moves off of a small know/screen panel so I donât think itâs an issue of drivers or anything like that failing. I honestly wasnât sure if my issue lied with the Arduino, Wiring, or the switch from Marlin to Grbl? I figured this would be the best place to get an idea of that. The other 3 motors initialize, however they are non-responsive to any movement commands that I send through cncjs. However, when I initialize everything two motors do not energize (one x-axis motor, and the z-axis motor). and use it as homing for the z- axis something like this : include home I have a PC that is dedicated to the CNC I have there, and use Cncjs desktop application to send any files etc. When I got it, I knew he had Marlin on the Arduino and had been just using a SD card to put files in. Iâve recently acquired a CNC that we have been using at work - an MPCNC, that just isnât getting used here and I would love the upgrade for home. PLease what are the pinout for rotary axis (A,B) on arduino mega, i have been looking buti cant find then with out using the ramp 1.4 shield. First of all thanks for taking the time to give me your thoughts ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |